A relação entre o preço e a configuração do equipamento de condensação por adsorção de vocs
A qualidade do equipamento de condensação por adsorção vocs deve ser garantida. Este pode ser utilizado com confiança. A razão para o consumo de energia também pode ser o facto de o gás aspirado pelo compressor BITZER permitir um certo grau de sobreaquecimento, mas o sobreaquecimento é demasiado grande. O volume específico aumenta, a capacidade de resfriamento diminui e o consumo relativo de energia aumenta. O compressor Bucher chega à geada, fecha rapidamente a pequena válvula de sucção, reduz drasticamente a quantidade de refrigeração...
As the evaporation temperature of the vocs adsorption condensing equipment decreases, the compression ratio of the BITZER compressor increases, and the energy consumption per unit of cooling capacity increases. When the evaporation temperature is lowered by 1 ° C, it consumes 3% to 4% more. Therefore, the evaporation temperature difference is reduced as much as possible, and the evaporation temperature is increased, which not only saves power consumption, but also improves the relative humidity of the cold room.
During the cooling process, the condensing temperature increases, the compression ratio of the compressor increases, and the energy consumption per unit of cooling capacity increases. If the heat exchange surface of the condenser and the evaporator is covered with an oil layer, the condensation temperature rises and the evaporation temperature decreases, resulting in a decrease in the amount of cooling and an increase in power consumption.
When the scale of the wall of the condenser of the condensing device of the condensing device reaches 1.5 mm, the condensation temperature rises by 2.8 ° C than the temperature before the fouling, and the power consumption increases by 9.7. The vocs adsorption condensing device evaporator surface is covered with a layer of frost, which reduces the heat transfer coefficient. Especially when the outer surface of the finned tube is frosted, it not only increases the heat transfer resistance but also makes the air flow between the fins difficult. Reduce the heat transfer coefficient and heat dissipation area of the exterior. When the indoor temperature is lower than 0 °C, when the temperature difference between the two sides of the evaporator tube group is 10 °C, the heat transfer coefficient of the evaporator after working for one month is about 70 before frosting.
The price of vocs adsorption condensing equipment is still appropriate depending on the configuration. Wuxi Guanya (LNEYA) has been carefully developed and achieved satisfactory results.

Recomendações relacionadas
-
Partilha de conhecimentos sobre a limpeza de condutas de chillers de alta potência
888Para muitas empresas, devido à fraca sensibilização para a manutenção diária dos chillers de alta potência, os chillers industriais de alta potência não são objeto de uma manutenção eficaz há muito tempo. Se os chillers industriais de alta potência não tiverem a manutenção necessária, ...
Ver pormenores -
Nós somos LNEYA-um fabricante de refrigeradores
934Existem muitos fabricantes de refrigeradores industriais no mundo, especialmente JULABO, huber, etc., que são conhecidos no sector. O que é que sabe sobre a tecnologia de produção de refrigeradores industriais? Atualmente, em muitas produções industriais, a indu...
Ver pormenores -
Como escolher o circulador quente e frio certo?
1040The hot and cold circulator is widely used in the pharmaceutical and chemical industry to provide users with hot and cold controlled, uniform temperature and constant temperature. It can also be directly equipped with reactors, reactors, etc. fo...
Ver pormenores -
How to Debug the Expansion Valve of Low Temperature Freezer?
1092The effective operation of low temperature freezer is relevant to the needed refrigerating effect. It is crucial to correct expansion valve if better cooling effect is wanted. So, how to debug the expansion valve of low temperature freezer?During ...
Ver pormenores