Como resolver o problema do abastecimento de água no sistema de refrigeração de baixa temperatura
Due to the improper operation of low temperature chiller system, there is the possibility of water entering into refrigerant system. Therefore, in view of the problem of water supply in low temperature chiller system, process guidance is formulated to serve as a reference for maintenance.
1. Analyse the reasons. Check the whole low temperature chiller system to confirm the cause of freezing damage and find out the leak point.
2. Blow dirt in sections.
(1) First, air compressor can be used to blow water (save nitrogen), until no water mist precipitate. Then blow with high pressure nitrogen, at the same time, heat the nitrogen (the nitrogen cylinder is prohibited from heating).
(2) Because the pipeline of baixo temperature chiller system is complex, water can be blown out in segments by using welding torch in some parts according to specific conditions.
(3) Heat and dry. The capillary, thermal expansion valve, compressor and other small components can be placed in the oven to bake and dry. Do replace the refrigerating oil in the compressor after the water is dried.
1. Vacuum drying
(1) Restore the pipeline and maintain the nitrogen pressure to ensure the air tightness of the system. Then connect the vacuum pump to the system for vacuum drying. (Dry filter barrel should be added to the front end of vacuum pump to avoid excessive water and gas entering the vacuum pump)
(2) In the process of vacuum drying, heat the place where water is easily stored in the pipeline, and the time can be determined according to the site.
2. Debugging and running.
(1) Make sure that the water in the system is basically removed.
(2) Connect the external drying filter barrel to the system and replace the desiccant after running for 5 minutes. At the same time, observe the operating parameters of the unit and pay attention to the sound of the compressor. If the dry filter is cold, the expansion valve frosts, and there is a pressure difference of more than 0.5 kg before and after the return air filter, stop the compressor immediately.
3. Completion of maintenance
(1) Remove the refrigerant pipe from the drying filter barrel and restore it.
(2) Check the supplementary refrigerant quantity. Turn on and check the machine running parameters to confirm normal.
Recomendações relacionadas
-
O que deve ser considerado ao comprar um sistema de arrefecimento de potência de motor arrefecido a óleo?
960A compra de objectos não é mais do que baseada em vários tipos de métodos: informar-se junto das pessoas que o rodeiam, pesquisar e consultar a Internet por si próprio, de modo a evitar alguns desvios. 1. Requisitos dos parâmetros: Encomendar na Internet é...
Ver pormenores -
Effect of evaporator on refrigeration system in special instrument for low temperature experiment
1240The low temperature experiment special instrument is LNEYA's refrigeration heating equipment for the laboratory. The importance of the evaporator is self-evident. So what effect does the evaporator have on the refrigeration system? According to di...
Ver pormenores -
Sistema de controlo integrado do dispositivo de ciclo de alta e baixa temperatura Dispositivos de utilização da série ZLF
1041With the development of society, the chemical industry has been further developed, and the temperature system control of the reactor has been strengthened, so as to ensure that the monitoring environment is in a good state, to ensure that the temp...
Ver pormenores -
Influência do óleo de congelação no sistema de ensaio do motor de tração de veículos de energia nova
1179O perigo do óleo de refrigeração no sistema de teste do motor de tração do veículo de energia nova aumenta a temperatura de condensação e a pressão de condensação; a transferência de calor do condensador deteriora-se. Porque a película de óleo produzida pelo óleo que entra no sistema de teste do motor de tração de...
Ver pormenores